Benefits of JTAG Boundary-Scan by JTAG Technologies

0 375

To make the device valuable printed circuit boards are very much beneficial. Various technologies and electronics use Printed circuit boards. For the proper functioning of the equipment, it is very much necessary to test the PCB. Boundary-scan is also known as the JTAG boundary-scan.

It means the PCB testing, which checks if the device is correctly inserted and soldered on to the PCB for the proper functioning. JTAG technologies are the number one boundary-scan company that makes their boundary-scan products available in many factories and design labs. Just because of the manufacturing issues in the PCB, there can be malfunctioning in the devices and cause inconvenience.

So the manufacturer always goes for the professionals for the testing of the PCB.

Why is testing needed?
If we talk about the most crucial stage of PCB manufacturing, then testing is the most vital stage. It’s quite evident that sometimes during the production of the PCB; there can be errors and problems that are skipped. Leaving this as it is can make the failures and defects in the fields.

As said earlier that PCB is very much crucial for the working of a device so, manufacturers go for the testing companies. Many of the manufacturing companies like Intel, Analog device, Altera, lattice, Broadcom, and more, use JTAG Technologies. Throughout the production phase, the testing procedure makes you identify errors and issues that can create failures in devices.

The testing phase is very much essential during the production time rather than testing the PCB at its final stage. To ensure the high quality of the PCB manufacturing companies goes for the best boundary-scan.

Components that are tested in PCB:

Resistors:
The vital part of the PCB, to produce voltage; there are two terminals in this small device. An ohmmeter tests the resistor. If the reading in the digital multimeter comes high when connected with the lead, then it is because of the open resistor. It is tested when the resistor is isolated.

Capacitors:
During the stable energy capacitor, block the flow of direct current and support the indirect present. Capacitors are basically for storing energy in the form of the electrostatic field. To test the short, leak, or the malfunctioning of the capacitor voltage is applied.

Diodes:
This is the small device that transmits current in a single direction and blocks the current coming from the opposite direction. Experts are needed to prevent the damage in this sensitive small-device, and the JTAG boundary scan makes tested well for the proper functioning of the device.

These are the crucial PCB components that are tested under professionals. Manufacturing companies go for the testing during and after the manufacturing of the PCB. It is essential to check the PCB as it has complex electric parts to avoid faults and errors. Each component should be monitored to make the PCB work in its full potential, and JTAG technologies are the one dedicated boundary-scan company.

So, this is all about JTAG Technologies which you should know. Share your opinion in the comment section below.

Leave A Reply